|
|
involute
|
|
|
纷乱的,复杂的,内卷的,渐开线,内卷,恢复原状,消失
|
| 分类：
|
详细解释：
|
|
|
以下为句子列表：
英文: Abstract: Calculation of the module of a 45 pressure angle involute profile for a tapered splined shaft substituting for a delta profile is studied in this article.The formula of calculation is deduced and the influence of unsuitable module on contact zon
中文: 文摘:讨论了锥三角齿花键轴用45°压力角渐开线齿花键轴代替时，如何计算模数的问题，并推导出相应的计算公式，分析了模数选择不当对接触区的影响.
更详细...
英文: Abstract: In this paper,the biting condition of cold rolling process for involute spline manufacture is built up.The condition provides guarantee for the success of the process,and provides basis for tool design and tryout.
中文: 文摘:针对渐开线花键冷搓成形工艺建立了咬入条件，从而为冷搓工艺的顺利进行提供了保障，也为冷搓模具的设计与调试提供了依据。
更详细...
英文: Abstract: The therortical calculation of the bending stress of the root and experimental stress analysis on the modified profile and the standard involute tooth profile were made with the finite element method and the electric resistance strain film metho
中文: 文摘:分别用有限元和电阻应变片法对修形齿形和渐开线齿形进行齿根弯曲应力计算与实验应力分析.结果证明在弯曲强度方面修形齿形比标准渐开线齿形更优越.
更详细...
英文: Abstract: This paper derives thecalculating formulas to the contact strength and oil-film thickness of the involute spur gear according to hydrodynamic lubrication principle.Through check with test,shows that they may rully replace now available Hertz for
中文: 文摘:根据流体动力润滑原理，推导出了渐开线直齿圆柱齿轮接触强度及油膜厚度的计算公式，通过实验验证，说明它们可以完全分别代替现有的赫芝公式及通森公式。
更详细...
英文: A New Technology of Involute Spline Broach Grinding and Profile Design
中文: 渐开线花键拉刀齿侧磨削新工艺及齿形设计
更详细...
|
|
|
|
|
