|
The results show that the exhaust fan current increases with frosting enhancement, while the increasing speed gets slower in the end of frosting, and the curves of current are slightly different at different voltages; that the evaporation temperature decr
|
|
|
结果表明，排风机电流随结霜厚度的增加而增大，增加速率在结霜后期趋缓，不同电压下电流变化曲线略有不同；蒸发温度随结霜厚度的增加而降低，下降速度越来越快；使用根据实验结果提出的基于排风机电流和蒸发温度联合控制的智能除霜方法可以基本避免误除霜动作。 |
|
The results show that the expected maximum temperature in the coal pile will be lower than 90℃ when the gas phase in the pile is saturated with water vapor.However, it will be higher than 100℃, if the relative humidity of the gas flow in the pile is decre
|
|
|
分析结果表明：当煤堆内水蒸气达到饱和时，预计的煤堆最高温度将低于90℃；而当煤堆中气流的相对湿度减小时，预计的煤堆最高温度将会超过100℃。 |
|
The results show that the fighter with thrust vector have smaller radius, shorter time and better maneuver performance.
|
|
|
结果表明，作战飞机带推力矢量后，完成半筋斗和加力盘旋机动动作的空间减小，时间缩短，机动性能得到了提高。 |
|
The results show that the fine sintering will be gained in the reasonable laser technical parameter, which can improve densenses and wear resistance, inaugurate a new technique of manufacture diamond tools.
|
|
|
结果表明，在合适的激光工艺参数下可以得到组织结构良好的金刚石微粉压坯烧结体，显著提高烧结体的致密性和耐磨性，开辟了一种金刚石工具制造的新工艺。 |
|
The results show that the formulae have good precision and reasonable application when D35 is used in all formulae.
|
|
|
当统一采用D35时，各公式都具有较好的精度和适用性。 |
|
The results show that the fracture of a broken tube is a kind of expansion form and a typical ductile fracture, and has instantaneous overheat blowout characteristic under the high temperature.
|
|
|
结果表明，爆管断口为胀开式爆口，为典型的塑性断口，具有高温瞬时过热爆管特征。 |
|
The results show that the fracture surface is characterized by a combination of most intergranular brittle regions and a few cleavage regions, and there are finer precipitations on grainboundaries.
|
|
|
结果表明，成型模裂纹断口形态呈沿晶特征，沿晶面上有细小析出物，为脆性断裂。 |
|
The results show that the geochemical fields have three different multifractal modes: The first one is a simple multifractal model with only two parts and the geochemical elements have no mineral enrichment; The second one is a mighty enrichment multifrac
|
|
|
对“元素含量－面积”双对数图的形态进行分析，将地球化学异常多重分形特征模式分为3种类型：模式Ⅰ为可拟合为2条直线段的简单多重分形模式，具有该模式的元素在研究区内没有成矿富集的趋势，不存在实质性的致矿异常；模式Ⅱ为可以拟合为3条直线段的高富集多重分形模式，它在模式Ⅰ的基础上叠加有高含量的异常场，具有该模式的元素在研究区内存在较强的局部富集，成矿的可能性很大；模式Ⅲ为可拟合成3条直线段的低富集多重分形模式，它在模式Ⅰ的基础上叠加的是较弱的异常场，具有该模式的元素在研究区内有较弱的矿化作用。 |
|
The results show that the grape resources have diversity in shape and average weight of bunch and berry, total sugar content, total acid content, color of skin, firmness of flesh, particular flavor.
|
|
|
结果表明，在葡萄果穗形状、果穗大小、果粒形状、果粒大小、果粒重量、可溶性总糖含量、总酸含量、果实颜色、果肉硬度和香味等方面均存在丰富的遗传多样性。 |
|
The results show that the heat preservation coating and its proper thickness are favorable to the enhancement of filling mold speed of aluminium alloy; the higher the pouring temperature is and the larger the ratio of hollow areas of vertical pouring is,
|
|
|
结果表明：保温涂料及一定的涂层厚度有利于提高铝液的充型速度；浇注温度越高、直浇道空心面积率越大，铝液充型速度越快；模样厚度太厚或太薄，均会使铝液充型速度降低；一定的直浇道长度及直浇道面积有利于提高铝液的充型速度；施加负压会使铝液的充型速度大大提高，但负压过大会增大铸造缺陷。 |
|
The results show that the heaviest stress concentration is found at the interval nozzle-vessel junction of the longitudinal symmetry plane, while the stress concentration around the external junction is decrease because of the welded joint.
|
|
|
计算结果表明，纵向对称面筒体与接管的内相贯处是应力集中最严重的部位，外相贯处由于有焊接接头而使应力集中大大缓解。 |
