|
Check the blade grinds as above. Daggers are often challenging in this regard.
|
|
|
如同上面折叠刀介绍的方法检查刃口打磨。短剑在刃磨方面比较有挑战性。 |
|
Check the box beside Completed listings only.Then fill in all the parameters for the item you are researching and press the Searchbutton.
|
|
|
检查“完整的广告“旁边的选框，然后填入你要搜索目录的所有参数点击“搜索“按钮。 |
|
Check the clearance among the spare of cutter termly. If the clearance is too large, adjust the washer to the reasonable clearance.
|
|
|
应定期检查切割器刀片间隙，如间隙过大应调整压刃器垫片来达到理想间隙。 |
|
Check the clothing in front of you .take it back please.
|
|
|
请检查一下你面前的衣物并取回. |
|
Check the completeness and correctness of quality documentation of manufacturers.
|
|
|
检查和记录制造商的检测文件的完整性和正确性。 |
|
Check the connection of control circuit shall be in accordance with drawings, the continuity of each circuit, and the insulation resistance against earth.
|
|
|
按电路图检查控制回路接线正确，各回路连续性试验正确，对地绝缘电阻符合要求。 |
|
Check the destination country(on the alphabetically listed chart opposite) for the correct zone, then refer to the chart on the left.
|
|
|
对照左边以英文字母顺序的目的地国家表，查出相应的所属区域，再参照右边的价目表，即可查出运费。 |
|
Check the documentation for your hardware.
|
|
|
为你的硬件检查文件编写。 |
|
Check the edge - the edge overhang should be consistent throughout the perimeter of the countertop.
|
|
|
检查边缘：悬垂边缘必须位于台面界面以内。 |
|
Check the engine tail pipe on metal particles and visible damage .
|
|
|
检查发动机尾喷管无金属颗粒和损坏。 |
|
Check the gear wheel drive in the groove of the wall, select four gear wheel (red pinion is not used) of different size for use, load heavy gear wheel, times of heavy gear wheel, times of light gear wheel, minimum gear wheel most onto separately from left
|
|
|
检查墙壁凹槽中的齿轮驱动装置，选用大小不同的四个齿轮（红色的小齿轮不用），从左到右分别装上最大的齿轮、次大的齿轮、次小的齿轮、最小的齿轮，并使齿轮间相互交结，拉下拉闸，驱动完成。 |
