|
| Abstract: In this paper,the complex prescription of ATMP,Molybate and Polyaerylamide is optimized under the simulated industrial water quality con ditions,through the corrupting experiment of carbon steel flats and the inhibiti on experiment of conc entra |
中文意思：
文摘:在模拟工业水质条件下，通过静态碳钢挂片腐蚀实验及浓缩水阻垢实验，以加权单纯形法优化了氨基三甲叉瞵酸(ATMP)，钼酸铵及聚丙烯酰胺三种药剂的复合配方.实验表明，优化所得配方在较低的药剂浓度条件下达到了较高的缓蚀和阻垢效果，从而降低工业成本，并且实验时间短，实验成本低. |
以下为相关句子列表(点击查看，可以看对应的解释）：
|
|
Abstract: In this paper,the authors give a description of the strong motion and damage caused by the earthquake of MS 7.4 occurring in Izmit,Turkey on August 17,1999,including the strong ground motion of the Izmit earthquake of MS 7.4,the earthquake inten
|
|
|
文摘:介绍了1999年8月17日土耳其伊兹米特7.4级地震的强地震动和地震灾害，包括：伊兹米特7.4级地震的强地面运动、地震烈度分布、地震震害以及地震破坏原因浅析。 |
|
Abstract: In this paper,the backward simulation was summarizd at home andabroad,the characteristics of shell nosing were introduced,the theory and scheme of backward simul-ation of shell nosing was constructed,the determined methods of the boundary condit
|
|
|
文摘:综述了国内外反向模拟技术，介绍了收口工艺特点，建立了收口反向模拟技术的理论和系统流程，并针对收口工艺提出了反向模拟边界条件确定方法。 |
|
Abstract: In this paper,the basic demands of recirculation fumigation of phosphine in Chin ese national grain storage depots are discussed,which include safety,phosphine c oncentration,disribution,gas tightness,running state and corrosion.
|
|
|
文摘:本文讨论了中央直属储备粮食仓库采用有中国特色的环流熏蒸中应达到的基本要求，从熏蒸过程的安全性、浓度分布要求、气密性要求、以及设备工况、防腐蚀等方面进行了阐述。 |
|
Abstract: In this paper,the biting condition of cold rolling process for involute spline manufacture is built up.The condition provides guarantee for the success of the process,and provides basis for tool design and tryout.
|
|
|
文摘:针对渐开线花键冷搓成形工艺建立了咬入条件，从而为冷搓工艺的顺利进行提供了保障，也为冷搓模具的设计与调试提供了依据。 |
|
Abstract: In this paper,the cellular glass was introduced by using waste glass as raw material,added a little foaming addition and chemical material,with low-temperature (760-810℃)foaming technigue.The influence has been studied between material's composi
|
|
|
文摘:利用回收的废玻璃为泡沫玻璃的主要原料，添加少量的发泡剂和一些其它化工原料，采用低温(760～810℃)发泡工艺，探讨了配合料的配方组成和不同的发泡工艺制度对泡沫玻璃性能的影响，通过比较，得出了合理的泡沫玻璃的配方及发泡工艺制度；试制出的泡沫玻璃具有容重低，抗压强度大，烧成周期短，易于控制的特点。 |
|
Abstract: In this paper,the complex prescription of ATMP,Molybate and Polyaerylamide is optimized under the simulated industrial water quality con ditions,through the corrupting experiment of carbon steel flats and the inhibiti on experiment of conc entra
|
|
|
文摘:在模拟工业水质条件下，通过静态碳钢挂片腐蚀实验及浓缩水阻垢实验，以加权单纯形法优化了氨基三甲叉瞵酸(ATMP)，钼酸铵及聚丙烯酰胺三种药剂的复合配方.实验表明，优化所得配方在较低的药剂浓度条件下达到了较高的缓蚀和阻垢效果，从而降低工业成本，并且实验时间短，实验成本低. |
|
Abstract: In this paper,the contour evolution method of numerically-controlled electrochemical machining is described.
|
|
|
文摘:阐述了数控展成电解加工中展成运动的实现方法。 |
|
Abstract: In this paper,the double-speed synchronous sampling method is introduce d to the power system harmonic measurement, and the corresponding algorithm mode l of DFT is deduced.
|
|
|
文摘:将双速率同步采样法用于电力系统谐波测量，导出相应的DFT计算模型。 |
|
Abstract: In this paper,the effect of pre-stress on peen-forming is studied by experiments,the results show that pre-stress can change the relationship between pre-deformation and pre-stress shot peen deformation,and that 0.05%～0.1%pre-strain is compareti
|
|
|
文摘:对预应力喷丸成形进行了试验研究，指出预应力可以改变其对应的预变形与预应力喷丸变形之间的大小关系，在以改善喷丸型面纵向直线度为主要目的的预应力喷丸成形中，预应变取值0.5/1000～1/1000较为适宜。 |
|
Abstract: In this paper,the efficient stress method is used as main means,while the Railway Engineering Anti-Earthquake Design Specification and the dynamic triaxial test are used as additional means.The authors analyze the ground layer liquefaction of sh
|
|
|
文摘:以有效应力原理的有限元计算分析为主、铁路工程抗震设计规范及室内动三轴实验为辅，对修建在粉土或粉细砂层中的盾构隧道进行了两种不同埋深情况下的液化分析，得出了埋深不同液化区出现区域不同的结论，并提出隧道抗液化的合理埋深。 |
|
Abstract: In this paper,the feasibility of the separation of nano-CaCO3 slurry is studied and the operating parameters affecting the process are investigated.
|
|
|
文摘:论证了用板框过滤纳米碳酸钙悬浮液的可能性，讨论了操作条件对该分离过程的影响，并指出了这种方法存在的不足及改进的方向。 |
|
|
|
