|
Install the Flow Measurement Device in a straight run of pipe making sure that the flow arrow on the Flow Measurement Device points in the direction of the water flow.
|
|
|
在管道的直线段安装流量测量装置，确保流量测量装置上的箭头指向水流的流向。 |
|
Install the TV antennas away from the FM/AM antenna.
|
|
|
使电视天线安装在远离FM/AM天线之处。 |
|
Install the column into detector. Check the instrument maufacture's manual for the proper insertion distance.
|
|
|
将柱子装进检测器。查阅仪器生产商的说明书，以便获取合适的安装距离。 |
|
Install the guide frame of the pin connector.
|
|
|
装销钉连接器导向向臂。 |
|
Install the handbook , all assembling of complete fastening screw according to, read all above important safe explanation carefully please.
|
|
|
根据本安装手册,完全紧固所有的装配螺钉,请认真阅读以上重要的安全说明. |
|
Install the main unit to the in-dash location, and the connection box under the navigator's seat, etc.
|
|
|
把主机安装到仪表板上。并把连接盒安装到副驾驶座的下面。 |
|
Install the new element and gasket, checking for correct positioning. Reconnect the electrical terminals and tighten the retaining bolt.
|
|
|
安装新的加热棒和垫圈，确认是否位置是否正确。重新连接电气端子，旋紧固定螺栓。 |
|
Install the unit so that the monitor when opened up will not block access to the hazard switch or other important controls.
|
|
|
安装本装置，使监视器打开时不应妨碍危急开关或其它重要控制部件的使用。 |
|
Install the valve bonnet. Torque to 70 ft./lbs.
|
|
|
安装阀盖。扭矩为70英尺/磅。 |
|
Install the water piping and fittings as shown in Figure 6.
|
|
|
按照图6所示安装水管线和连接件。 |
|
Install this valve between any ANSI Class 125 or 150 flange. Cast iron, bronze, plastic or steel flanges may be used. No flange gaskets are required.
|
|
|
安装在ANSI标准125或150磅级法兰之间。也可采用铸铁，青铜，塑料或钢法兰。不需要法兰垫圈。 |
