|
The result showed that the oil adsorption increased from 61% to 97%.
|
|
|
结果表明微孔淀粉的吸油率从原工艺的61%提高到97%，具有很好的效果。 |
|
The result showed that the pump has the advantages of larger discharge and smaller pulsation.
|
|
|
结果表明，该泵具有排量大、脉动小等优点。 |
|
The result showed that the rates of oxygen consumption of F. chinensis, water column and sediment were 3.74%, 17.35% and 78.91% respectively in soiled pond shrimp culture, and those of Litopenaeus vannamei and water column were 72.67% and 27.33% respectiv
|
|
|
结果表明，在中国对虾的土池养殖环境中，对虾耗氧量、水柱和底质耗氧量分别占总耗氧量的3.74%、17.35%和78.91%；在凡纳滨对虾的工厂化养殖环境中，对虾耗氧量占总耗氧的72.67%，水柱耗氧占27.33%。 |
|
The result showed that the recombinant rainbow trout growth hormone expression by yeast Y33 (pMArGH16) had biologic activity, and been absorbed by fish intestine to enhance the growth of the fish.
|
|
|
结果表明，酵母胞内表达的虹鳟生长激素具有生物活性，能够经口服被鱼体肠道吸收，对罗非鱼具有明显的促生长作用。 |
|
The result showed that the red koji produced by millet could produce yield of 30%-35% and had better quality and higher color value than that produced by corn.
|
|
|
该文介绍了以小米为原料，采用巨红3号红曲霉菌种，生产红曲的技术，其中包括原料处理、冷却与接种、保温培养等，接种量为1%时，生产的红曲质量优于玉米，籼米原料，色价高，出曲率30%~35%。 |
|
The result showed that the sensory perception and taste of cakes containing peanut residue were acceptable at 10% (w/w).
|
|
|
当花生渣粉添加量为10%时，制得的产品口感较好。 |
|
The result showed that the survivor rate, seedling height, seedling weight and vigor index of the yellow-seeded were lower than that of the black-seeded, but with higher electric conductivity rate.
|
|
|
结果表明，甘蓝型黄籽油菜的相对成苗率、相对苗高、相对苗重、活力指数低于黑籽油菜，单位电导率高于黑籽油菜。 |
|
The result showed that the tiny difference of land use structure in past years were reported in the method of ideal-point, integrating land use with social and economic development and maintenance of eco-system balance to achieve a unified benefit of soci
|
|
|
研究结果表明：“理想点法”能反映出历年土地利用结构变化间的细微差别，为使土地利用寓于社会经济发展和维持生态系统平衡之中，最终谋求社会、经济、生态三效益的统一提供有价值的参考。 |
|
The result showed that two-stage process was practical to pre-press particleboard mat then to hot-press in mold to produce tridimensional decorative particleboard.
|
|
|
结果表明：以刨花预压制坯再进行热压模压的两步法刨花模压工艺，制备具有立体结构的刨花模压装饰板材的技术路线是可行的。 |
|
The result showed that with increasing of hard segment content,the crystallinity of copolymer increased, thehard se gment content and the molecular weight of polyether were influence on the mechanical properties of copolymers.
|
|
|
结果表明，共聚物的结晶度随聚酯硬段含量的增加而增加，而其力学性能则受聚酯硬段含量和聚醚分子量的影响。 |
|
The result showed the difference of mechanical properties of HSLA steel results from the troostite and banded structure which are closely relative to mamgamese content.
|
|
|
结果表明屈氏体组织以及带状组织是造成低合金钢板强度、塑性差异主要原因，而屈氏体组织、带状组织的产生和锰含量有很大关系。 |
