|
The flow behavior of resin, water outlet structure at bottom of the mixed bed, water inlet position of hydraulic transportation, water intake ratio, and pneumatic transportation etc. have been analysed, giving out optimal selection of them combined with r
|
|
|
对树脂的流动性能、混床底部出水结构、水力输送进水位置、进水比例以及气力输送等进行了分析，并结合实际给出了最佳选择。 |
|
The flow capacity of the straight pattern valve in the full open position is typically 20% lower than the oblique type.
|
|
|
全开位置上的直线式结构阀门通常比倾斜式结构的流通能力小20%. |
|
The flow characteristics of rotor-stator cavity system with blade-cooling flow and disk-cooling flow was experimentally studied.
|
|
|
摘要采用实验方法，对具有中心进气、两个出口的盘腔系统的流动特性进行了研究。 |
|
The flow characteristics, eddy structure and energy dissipated mechanism of multi-horizontal submerged jets (MHSJ) are studied by means of 3-D numerical simulation.
|
|
|
摘要采用三维数值模拟，研究了多股多层水平淹没射流的流动特性、漩涡结构和消能机理。 |
|
The flow chart, key techniques and working procedure of the filter were introduced.
|
|
|
介绍了该滤波算法的工作流程图、关键技术及工作步骤。 |
|
The flow coefficient (Cv) listed in the tables apply to fully open valves only.
|
|
|
表中所列流量系数仅适用于全开状态下的阀门。 |
|
The flow diagram should encompass an additional page.
|
|
|
流程图则包含于附加页数中。 |
|
The flow dynamic axis in the distorted models is smoother than that in the undistorted model, while the flow horizontal gradient in the distortion model is smaller than that in the undistorted model.
|
|
|
在河工模型的条件下，选取不同变态模型，对环流进行了计算，研究了变率对弯道水流的相似的影响，并给出了初步分析。 |
|
The flow fields of the impellers were calculated by solving three-dimensional Navier-Stokes equations.
|
|
|
对这两个离心压气机叶轮内部流场进行了三维粘性计算，给出了计算结果。 |
|
The flow in outlet structure of pressure tunnel is simulated by using Monte Carlo method with irregular random walking grids in this paper.
|
|
|
摘要利用不规则游动网格的蒙特卡罗法对有压隧洞出口段水流进行了数值模拟。 |
|
The flow is linear, with some iterations in the planning phase.
|
|
|
过程流程是直线的，在计划阶段会有一些迭代。 |
