|
The calculation procedure and method of the piston leans towards the jar to the influence of life-span of the engine, taken farm transporter 375engine as an example, has been carefully introduced and quantitatively analyzed in this paper.
|
|
|
摘要以农用车375柴油机为例、详细介绍和定量分析了活塞偏缸对柴油机寿命影响的计算步骤和方法。 |
|
The calculation result of passed flow rate in pipe section of pipeline network is significantly influenced by the momentum exchange and the local energy losses at junctions for the pipeline network comprised of the pipes of larger diameter and shorter len
|
|
|
摘要对于管径较大、管段长度较短的管网，结点处的动量交换和局部能量损失显著影响管网中管段通过流量的计算结果。 |
|
The calculation result shows that more exact and reasonable calculation result of seepage field can be obtained by using this idea and method to calculate the earth dam seepage.
|
|
|
算例结果表明，应用思想与方法计算土石坝渗流，可以获得较为准确合理的渗流场计算结果。 |
|
The calculation result shows that the model can keep the balance of the link level budget margin among the different spot-beam cellars, the onboard power in satellite can be used more effectively and the model is possessed of better applied value.
|
|
|
计算结果表明，该点波束模型能使各点波束小区的链路电平预算余量达到平衡，并使星上功率得到更有效的利用，弥补了现有模型的不足，具有较高的应用价值。 |
|
The calculation results demonstrate the effective eccentricity and the lifting force of the upper drill string are the major influential factors.
|
|
|
计算结果表明，有效偏心距和上部钻柱的提升力是影响近井口套管偏磨的主要因素。 |
|
The calculation results obviously show that the width and center position of band gaps depend on the position and the refractive index as well as the radius of the cylinder doped with impurities.
|
|
|
数值结果表明，对于一定的入射方向，光子晶体中的带隙的宽度、中心位置都受到掺杂所处的位置、掺杂物的折射率、掺杂柱的粗细不同程度的影响。 |
|
The calculation results show that the correlation between the multiplicity of intermediate mass fragments N(subscript IMF) and total number of charged particles N(subscript c) is a sensitive observable for probing the isospin-dependent in-medium nucleon-n
|
|
|
计算结果表明在所选能区，中等质量碎片的多重性与带电粒子总数之间的关联是提取介质中核子－核子碰撞截面的灵敏观测量，而此时对称势的同位旋效应却不明显。 |
|
The calculation results show that the stress distributing of the plug drawing tube is different because of different dies, the drawing force and pulling force are lager in arc die and the diameter and wall thickness are closer to the designing value in co
|
|
|
计算结果表明，不同的模具，芯拔管的应力分布不同，弧形模成型的拔制力与芯棒后拉力较大，锥形模成型后钢管的直径与壁厚更接近设计值。 |
|
The calculation results show that the value of crack width obtained from the new and old hydraulic design Specification is different, especially, the member with thicker concrete protective layer, and that the value obtained from industrical and civil bui
|
|
|
实例表明新、旧规范的裂缝宽度值计算差异较大，特别是混凝土保护层厚度较大时，同时工民建规范计算公式的计算值较水工规范计算公式的值大，故偏于安全。 |
|
The calculation rules of the system depend on Regulations for classification on agricultural land and Regulations for gradation on agricultural land.
|
|
|
系统的设计采用组件式地理信息系统和计算机编程技术，系统的计算原理依据国家农用地分等与定级规程确定。 |
|
The calculation was difficult, but we finally cracked it.
|
|
|
计算起来很费劲, 然而我们终於解决了. |
