|
The moisture detection system shall be designed to detect the entrance of moisture in both the lower oil seal housing and the air-filled motor stator housing.
|
|
|
潮气检测系统应该用于检测是否有潮气进入下部油封箱体或风冷式电机定子箱。 |
|
The moisture detection system shall be designed to detect the entrance of moisture in the stator and lower oil seal housing.
|
|
|
潮气检测系统应该用于检测是否有潮气进入定子和下部油封箱体。 |
|
The moisture sensing probe leads shall terminate at a conductance relay located in the control panel, which shall provide an alarm in the event of moisture intrusion.
|
|
|
潮气感应探头末端应该位于控制面板的导纳继电器附近，在潮气侵入时应该能够发出警报。 |
|
The moisturizer we deal in was awarded a gold medal at an international exposition.
|
|
|
我们的加湿器曾获得国际博览会金奖。 |
|
The mold cavity number is used to group plastic cuvettes at production time; this helps to ensure the lowest cuvette-to-cuvette variation in extinction coefficient.
|
|
|
在生产过程中，通过铸模型腔的数量用来对塑料试管进行分类。这对于确定试管间的最低消光系数很有帮助。 |
|
The mold cavity was obtained by splitting mold base in parting surface.
|
|
|
模具型腔可采用分型面分割模板的方法获取。 |
|
The mold is then set down atop a layer of a liquid monomer on the surface of a chip.
|
|
|
接下来用紫外光射透石英板，使液体硬化成聚合物，再将晶片做进一步的完成步骤。 |
|
The molded PTFE ring is bonded into a groove in the disc face for maximum service life.
|
|
|
这种模铸聚四氟乙烯环粘合在阀瓣表面的槽内，最大限度延长使用寿命。 |
|
The molded PTFE ring is bonded into a seat ring groove in the face for maximum service life.
|
|
|
这种模铸聚四氟乙烯环粘合在阀座表面的阀座环槽内，最大限度延长使用寿命。 |
|
The mole bored (its way) underground.
|
|
|
鼹鼠在地下挖掘（路）. |
|
The mole quickly burrowed out of sight.
|
|
|
这只鼹鼠很快地钻出视线之外。 |
